RC-Connectors storefront


Mini-Futaba single pin multicopter signal wire

$1.99

This is a single wire connector cable, male to male, for connecting your Mini-Futaba RX to flight controller board. Examples of Mini-Futaba RXs are the Orange-RX R415, Futaba FAAST Receiver R616FFM, Flydream, and, Walkera. Note that Mini-Futaba connectors are another name for Molex PicoBlades, have a 1.25mm pitch, and always have the red wire in the middle!

Use for connecting just signal wires from your RX to flight controller board. Comes in white only.

Three choices for wire size - 26, 28, or 30 gauge.

Length is BETWEEN the connectors, so overall length is what you request plus ~1 inch. (length may vary 1/4" either way)

Many choices for length, from 2" all the way to 12".

These are NOT cheap imported cables. Each one is hand-made here at RCConnectors with your choice of wire and length needed without adding extra weight.

MAKE SURE TO CHOOSE WEIGHT AND LENGTH BELOW

Add to Cart:

  • Model: Mini-Futaba-multicopter-signal

Please Choose:

Gauge








Your IP Address is: 54.81.108.205
Copyright © 2017 RC-Connectors.com store. Powered by Zen Cart
Parse Time: 0.324 - Number of Queries: 599 - Query Time: 0.17659597236633