RC-Connectors.com StoreFront

Motor Extension - 2 pin


2-pin Motor extension for your Vapor/mini-vapor/AR6400 based brick, anything with a little 2-or-3-pin round socket connector (.05" on center)

30 gauge wires, any random colors


NOTE - this is only for using a 2-pin BRUSHED motor. If you're looking for all three wires for an AR6400 brick then look for the 3-pin extension in the UMX Beast section of the site

NOTE^2 - this would also work for an extension of the tail motor connector on a Blade 120SR, MSR, or MCP-X heli. If this is your use though, then check out the dedicated Blade 120SR/MSR/MCP-X sections of this site for other choices too.

NOTE^3 - Yes, these are yellow and grey wires, yours could be any two 30 gauge colors I happen to have lots of. The color really doesn't matter, as both ends are flippable. Just plug this into your brick, then your motor into it. If the motor spins backwards just flip over one end.

Add to Cart:

  • Model: motor-2-extension

Please Choose:

Your IP Address is:
Copyright © 2024 RC-Connectors.com. Powered by Zen Cart
Parse Time: 0.328 - Number of Queries: 230 - Query Time: 0.092352376571655